The products > Measuring devices > ALPTEC power factor controller > Technical characteristics

> ALPTEC Power factor controller
> Technical characteristics

ALPTEC Power factor controller

TECHNICAL CHARACTERISTICS

Auxiliary supply	ALPTEC 3	ALPTEC 5	ALPTEC 7	ALPTEC 12
Rated voltage Ue	380 to 415 Vac (other value on request)
Operating limit	-15% to +10% Ue
Rated frequency	50 or 60Hz ⁺_- 1% (self configurable)
Maximum consumption	6.2Va			5Va
Maximum power dissipated	2.7W			3W
Maximum power dissipated by output contact	0.5W with 5A
Immunity time for micro breakings	≤ 30 ms
No-voltage release	≥ 8 ms

Current input
Rated current le	5A (1A on request)
Operating limit	0.125 to 6A
Constant overload	+20%
Type of measurement	True RMS
Short time withstand current	10le for 1 s
Dynamic limit	20le for 10 ms
Input power	0.65 W

Control range
Power factor setting	0.80 ind to 0.80 cap
Reconnection time of the same step	5 to 240 s
Sensitivity	5 to 600 s / step

Output relay	ALPTEC 3	ALPTEC 5	ALPTEC 7	ALPTEC 12
Number of outputs	3	5	7	12
Type of outputs	3	3+2 C/O/F	5+2 C/O/F	10+2 C/O/F
Maximum current at contact common	12A
Rated capacity lth	5A
Rated operational voltage	250VAC
Maximum switching voltage	440VAC
Designation according to IEC/EN 60947 5-1 AC-DC	C250, B/400
Electrical life at 0.33A 250VAC and AC11 load conditions	5x10⁶ ops
Electrical life et 2A 400VAC and AC11 load conditions	2x10⁶ ops

Operating ambient conditions
Operating temperature	-20°C to +60°C
Storage temperature	-30°C to +80°C
Relative humidity	< 90%

Connections
Type of terminal	Removale / Plug-in
Cable cross section (min-max)	0.2-2.5 mm² (24-12AWG)
Tightening torque	0.8Nm (7lbin)

Enclosure	ALPTEC 3	ALPTEC 5	ALPTEC 7	ALPTEC 12
Version	Flush mount
Material	Thermoplastic NORYL SE1 GNF2			Thermoplastic LEXAN 3412R
Dimension W x H x D	96 x 96 x 65 mm			144 x 144 x 62 mm
Panel cut out dimension	91 x 91 mm			138.5 x 138.5 mm
Protection degree	IP 54			IP 41 (IP 54 with protection cover)
Weight	420 g	440 g	460 g	770 g

Reference standards

IEC/EN 61010-1, IEC/EN 61000-6-2, ENV 50204 ; CISPR 11 / EN 55011 ; 61000-3-3 ; IEC / EN60068-2-6 ; UL508 ; CSA C22.2 N° 14-95

Certification

cULus pending

Wiring diagram :

IMPORTANT!
a. For three-phase connection, the voltage input must be connected phase to phase; the current transformer must be connected on the remaining phase.
b. The polarity of the current/voltage input is indifferent.

WARNING!
Disconnect the line and the supply wshen operating on terminals.